Results 1 to 5 of 5

Thread: need help with 101 fanuc alarm; "reset/prog" not clearing it

  1. #1
    Join Date
    Sep 2007
    Posts
    9
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default need help with 101 fanuc alarm; "reset/prog" not clearing it

    Have Mori Seiki MH633 that was trying to load new progam into; control froze so cycled power. at start up get 101 clear memory alarm.
    Have tried nurmous times to use <reset> <prog> to clear program; not working; any help would be great.

  2. #2
    Join Date
    Jun 2007
    Posts
    21
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default

    I assume you held these keys in at the same time on power up??



    FYI to everyone reading this do not hold in just any keys on power up always be sure of what the keys are for because you can blow out parameter data.
    Programming is like ***: one mistake and you have to support it for the rest of your life

  3. #3
    Join Date
    Sep 2007
    Posts
    9
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default

    Yes have tried this with spare set of hands to push "OK" soft key;
    Control is locked up at this point. If i release "reset/prog keys control will
    initialize but has paramiter write enabled and clear memory alarms.

  4. #4
    Join Date
    Feb 2006
    Location
    Waukesha, WI
    Posts
    21
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default

    Procedure to clear alarm is:

    1 Press System key
    2 Press NC Ststem Soft Key
    3 Press shift key
    4 Press page down key
    5 A screen pops up above soft keys
    6 One of the selections is CLEAR 101 ALARM
    7 Use arrow keys to select and highlight
    8 Press input key
    9 Alarm should now be gone
    10 If alarm still persists, repeat procedure.

    RRL

  5. #5
    Join Date
    Sep 2007
    Posts
    9
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default

    Many Thanks RRL; Your procedure worked like a charm. alarm is gone and machine is back up and running. Again Thanks.

Similar Threads

  1. trouble clearing alarms on harrison cnc lathe
    By willdahuzz in forum Fadal, Fanuc, Fidia, Fryer
    Replies: 11
    Last Post: 01-20-11, 02:52 PM
  2. loading prb of part prog.
    By ashish in forum Fanuc Controls
    Replies: 2
    Last Post: 04-28-10, 02:20 AM
  3. clearing 300 APC Alarm : B axis need ZRN
    By misco01 in forum Fanuc Controls
    Replies: 1
    Last Post: 12-07-09, 12:42 PM
  4. Danichi 152 :fanuc 15T "OT007 z + overtravel (Hard) alarm" can't RESET.
    By jlpd in forum Machine Repair & Troubleshooting
    Replies: 0
    Last Post: 11-22-09, 09:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •