Results 1 to 4 of 4

Thread: Fanuc 6T - RS232 Help

  1. #1
    bcmfgtech Guest

    Default Fanuc 6T - RS232 Help

    I am trying to set up a Fanuc 6T controller on a Mori Seiki SL1 lathe for RS232 communications but I have been unable to successfully change the parameters. Can anyone offer any advice?

    Thanks.

  2. #2
    cnctech Guest

    Default

    Set the following parameters on the machine

    In the 'SET' mode select manual input mode and set following parameters
    INPUT DEVICE 1 1
    INPUT DEVICE 2 1
    INPUT UNIT 0
    PUNCH CODE 1
    TV CHECK 0
    In the 'PARAM' mode set following parameters
    #340 2
    #341 2
    #310,#311,#312,#313 (baud rate) = 0000 1001
    Baud Parameter value
    1200 0000 0111
    2400 0000 1000
    4800 0000 1001
    9600 0000 1010

    Set the following parameters on the PC


    Machine name Fanuc 6T
    Serial port COM2 (or any free COM port)
    Baud 4800
    Data bits 7
    Parity Even
    Stop bits 2

  3. #3
    unicohn Guest

    Default

    Hi
    I have some problem with my Fanuc 6M model B of Mitsui Seiki
    I have done follow your suggest. But I can't change the Parameter. I read another in forum as : Have to turn on PARAMETER Write Enable Switch. But Where is it, Can you teach me full to take it?
    And I have ones to you . How Have I do to set the D or H value in Offset table, Because my machine has not the left and right arrow button (up and down only), so I can't move the cussor to Offset value Column to change as newer fanuc. Please help me to do it
    Thanks a lot
    Best
    Unicohn

  4. #4
    soumen Guest

    Default

    Dear All ,
    I have one hitachi seiki lathe with Fanuc 6TB controller .
    Can you please send me the programming / operating manual for Fanuc 6TB ?
    regards

Similar Threads

  1. Fanuc ot rs232/how to send program
    By kanders in forum Fadal, Fanuc, Fidia, Fryer
    Replies: 5
    Last Post: 01-15-11, 09:58 AM
  2. Fanuc: DNC via Ethernet while Dprnt vis RS232
    By FatFingers in forum Fanuc Controls
    Replies: 4
    Last Post: 02-06-10, 06:45 AM
  3. RS232 FANUC OT TROUBLE
    By CWIND in forum Fanuc Controls
    Replies: 13
    Last Post: 05-12-09, 07:16 PM
  4. Fanuc 10T RS232 Problem
    By WorkingDogs in forum Fanuc Controls
    Replies: 6
    Last Post: 12-23-07, 04:36 PM
  5. FANUC 6M - RS232 Error 086
    By chinthakahk in forum Fanuc Controls
    Replies: 2
    Last Post: 09-27-07, 06:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •