Results 1 to 2 of 2

Thread: HAAS CNC TM-1 tool changer problem

  1. #1
    Join Date
    Mar 2011
    Location
    Waterford, Michigan
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default HAAS CNC TM-1 tool changer problem

    Hello everyone, I just signed up on this site and I have a problem. I am running a HAAS CNC Toolroom Mill (model TM-1). The tool will not release to replace it in the carousel. It will unclamp manually but not automatically. I thought the fingers were not letting go so the head wouldn't raise, but it does the same thing even with no tool in the spindle, and gives me a "tool clamp fault" warning on my controller screen. Any ideas??
    Last edited by eldubya; 03-29-11 at 08:56 AM.

  2. #2
    Join Date
    Apr 2009
    Posts
    132
    Thanks
    0
    Thanked 5 Times in 5 Posts

    Default Re: HAAS CNC TM-1 tool changer problem

    I suspect the carousel is out of alignment with the tool change position (height)
    Or the M19 spindle orient is off. Check the tool change position first.
    Good Luck!

Similar Threads

  1. Computer problem? Tool changer locked up Deckel 103V Siemens 840D
    By Chuck - Detroit in forum Machine Repair & Troubleshooting
    Replies: 4
    Last Post: 04-22-11, 03:26 PM
  2. Tool Changer Problem
    By Snowdad1 in forum Machine Repair & Troubleshooting
    Replies: 5
    Last Post: 01-26-11, 10:39 AM
  3. tool changer problems
    By stew22 in forum Machine Repair & Troubleshooting
    Replies: 1
    Last Post: 01-04-11, 10:26 PM
  4. CNC Tool Changer Inactive (ATC)
    By Wes Raczynski in forum General CNC & Manufacturing Discussion
    Replies: 6
    Last Post: 09-23-09, 10:24 AM
  5. tool changer / Monarch
    By andy in forum ALL Other Builders not listed below
    Replies: 2
    Last Post: 08-22-07, 03:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •