Results 1 to 3 of 3

Thread: x overtravel alarm (soft 1)

  1. #1
    Join Date
    Jul 2013
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default x overtravel alarm (soft 1)

    Hello,
    I have overtravel alarm on x-axis at my Daewoo lathe. Control is Fanuc 10 T.
    Did anybody know to solve the problem?

    Thanks in advance

  2. #2
    Join Date
    May 2017
    Location
    South England
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: x overtravel alarm (soft 1)

    Hello,
    It should be as simple as moving the axis out of overtravel in jog mode, and resetting the control to get rid of the alarm. Have you tried this and encountered an issue?

    If the machine isnt at the end of its travel it is possible the soft disconnect switch is stuck down and needs freeing/replacing.
    Will.

  3. #3
    Join Date
    Jul 2013
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: x overtravel alarm (soft 1)

    Thanks wsellors,
    Of course, to run axis opposite way, alarm can be reseted.
    Sorry, I

Similar Threads

  1. 1002 soft limit 2 CNC Alarm
    By luslugger in forum Machine Repair & Troubleshooting
    Replies: 7
    Last Post: 06-27-16, 06:03 PM
  2. ALARM SV 323 B disconnect by soft
    By angel1971 in forum Fanuc Controls
    Replies: 3
    Last Post: 07-05-12, 10:22 PM
  3. overtravel alarm?
    By hpgoh70 in forum Fanuc Controls
    Replies: 12
    Last Post: 06-14-09, 08:57 PM
  4. X-Axis overtravel alarm
    By rnagel in forum Fanuc Controls
    Replies: 3
    Last Post: 10-24-07, 12:55 PM
  5. Help with Alarm 436 Soft Thermal (OVC)
    By emc_1978 in forum Machine Repair & Troubleshooting
    Replies: 6
    Last Post: 09-24-07, 08:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •