i make programs for the VTEC FANUC i Series:
my shop has always done straight line grooves with either 1/4 up to 3/4" end mills and and lots of drilling.
we are trying to start cutting out a groove in the existing holes, with a t slot bit.
in order to do this we need to make a linear and circular interpulation, which is either a G3 or G2 ,Well when i set my tool paths , evrything looks good, when i do the simulation, but when i go to run the program. the only thing that the program reads is the linear path the it tells me i have an error. i need help with the settings, if anyone could help me out this would really help.