Results 1 to 3 of 3

Thread: Daewoo puma 10

  1. #1
    Indmach Guest

    Default Daewoo puma 10

    Spindle motor start slowly and does not run to the given speed in the programme, and it faults out when stop the programme and the alarm on the L E D is field current loss, after shutting the power if you wait for hour than you start it runs ok for few minutes than same problem the machine is daewoo puma 10 and control is 6t
    and also I have been using the machine from last 2 years its use to blow semiconductor fuses time to time the current is going over 100 amp when the spindle stop so it was blowing fuses time to time. I was thinking if its the motor than why it runs after we wait for one hour and restart again.
    Thanks
    Ron

  2. #2
    MysticMonkey Guest

    Default

    Get some one to check the insulation of the coils when the motor is hot/warm

  3. #3
    Join Date
    Sep 2005
    Location
    Wisconsin
    Posts
    1,004
    Thanks
    5
    Thanked 74 Times in 64 Posts

    Default

    Check if there are contactors for forward and reverse or for main power to spindle drive and check them to see if they are bad. Can you make the alarm happen consistantly?

Similar Threads

  1. Daewoo Puma 12S
    By semmach in forum Machine Repair & Troubleshooting
    Replies: 1
    Last Post: 06-22-09, 08:01 AM
  2. Daewoo puma 10
    By Indmach in forum Fagor Controls & Automation
    Replies: 0
    Last Post: 01-23-09, 07:33 PM
  3. Daewoo Puma 12S
    By semmach in forum Machine Repair & Troubleshooting
    Replies: 0
    Last Post: 10-21-08, 03:05 PM
  4. Daewoo Puma 240
    By Guest in forum Machine Repair & Troubleshooting
    Replies: 7
    Last Post: 07-17-07, 03:55 PM
  5. Daewoo Puma 240
    By Guest in forum Machine Repair & Troubleshooting
    Replies: 7
    Last Post: 07-17-07, 03:55 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •