Results 1 to 4 of 4

Thread: Optimize parameters for mills with tips

  1. #1
    Join Date
    Jul 2011
    Posts
    32
    Thanks
    8
    Thanked 0 Times in 0 Posts

    Default Optimize parameters for mills with tips

    Hello

    Thank you for entering in my post
    How important is optmizining parameters for a mill with tips?
    We assume we have a 50mm cutter on the same pass (same plunging depth, same spindle speed)
    If we machine this pass with a feed of 800mm/revolution rather than 1600mm/rev (optimized)
    Can we say that we are not only taking double time to do the same job but we are also wearing the tips?
    I remeber that the supplier of the tips normaly gives you the contact time (the actual time that the tips canbe used to take material off) and after that you should change themor at least checking them to see if they can do more than that
    Can we say that optimizing parameters saves time and tips ?
    Any suggestion according his matterwill be very appreciative
    Thank you in advance for your help
    Last edited by Petro; 06-17-13 at 10:11 PM.

  2. #2
    Join Date
    Aug 2012
    Posts
    7
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Optimize parameters for mills with tips

    Sandvik Corokey is a good guide for optimising cutting parameters. It is available as a pdf and as an app. It makes suggestions regarding the causes of different tool wear and correction factors for varying hardness and desired tool life. Check it out at sandvik.com

    DP

  3. #3
    Join Date
    Dec 2011
    Location
    Dallas, Texas, USA
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Optimize parameters for mills with tips

    Check out this software to optimize immediately at the machine.
    http://media.wix.com/ugd/3441d5_1fda...9bbc9e5c76.pdf

  4. #4
    Join Date
    Oct 2017
    Location
    Canada
    Posts
    44
    Thanks
    1
    Thanked 0 Times in 0 Posts

    Default Re: Optimize parameters for mills with tips

    Hi wdallen,

    Thank you for wonderful information.

Similar Threads

  1. The tips of my 20 mill cutter get loose ...
    By hoezap in forum General CNC & Manufacturing Discussion
    Replies: 1
    Last Post: 07-10-13, 09:26 PM
  2. Small Mills, Lathe Operator
    By DtotheOC in forum Introduce Yourself
    Replies: 4
    Last Post: 06-25-11, 11:39 AM
  3. Fagor 8055m tips tricks war stories?
    By R.D.O. in forum Introduce Yourself
    Replies: 6
    Last Post: 03-30-11, 07:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •