I have been playing around with the milling side of this lathe.
Having been somewhat luckyl with slots and hex-ing parts,
I haven't had anything that was too difficult. I am looking to make configurations that have a horizontal slot then moving C axis from CO to C90
while at a given X diameter.This darn thing is moving in X towards X0 while turning the spindle to C90. The Distance to go is suspect while it reads opposite what it is doing. Let me explain this, D.T.G. is starting at zero then it is increasing while the amount that relative X is decreasing. I hope this can possibly be explained correctly. so I am posting what I have hoping that somebody can see an obvious mistake. I am blinded by my unability to figure this out.I have been programming Fanucs for 15 years and been on this machine for over a year now.Also been in the machining business over 30 years.
Thank you all for reading.
-----------------------

ODEFG(PRACTICE SLOT MILLING)
G0 X30 Z30(Z0 1.6 FROM COLLET)
G50 S1000
NAT02(FFC 432/H13A)
G97 S1000 M42 M03
G0 X1.1 Z.1 T020202
G01 G95 Z.02 F.02
Z0 F.005
X-.06 F.01
X.725
G75 X.985 L-.130
Z-.130
X1.1 F.02
Z.1 F.05
G0 X30 Z30
M01
M05

NAT07(.156 EMILL VERT. MILLING HOLDER)
M110
G94 M146 M15
G0 X1.0 Z1.0 C0 T070707 SB=2000
G01 Z.1 F50.0 M13
Z.02 X.980 F5.0
G101 Z-.5 F5.0
C90
X1.5 F20.0
Z1.0 F100.0
M12
M109
M146
G95
G0 X30 Z30
M30(1.0 AL. BAR)

Console reads: OKUMA OSP-P200L

I am trying to simulate what it will take to make rifle bolts.
And yes legally.