Results 1 to 4 of 4

Thread: Rom parity error 998 fanuc

  1. #1
    Join Date
    Feb 2013
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Rom parity error 998 fanuc

    I have a 998 rom parity error checked everything possible
    I have no backup parameters how can I back up my parameters with this alarm on
    It's a fanuc o-m on a leadwell mcv-760

    Any help would be nice ?
    Last edited by Bob rock; 02-01-13 at 03:42 PM.

  2. #2
    Join Date
    Mar 2009
    Location
    Denmark
    Posts
    34
    Thanks
    0
    Thanked 6 Times in 5 Posts

    Default Re: Rom parity error 998 fanuc

    Hi Bob.

    I have seen a Fanuc technician grapping the parameters from the machine with a bad memory.
    I'm not sure what he was attaching to the controller, but they can help you.

    Best regard

    Arne Hjeresen
    Reparo.dk

  3. #3
    Join Date
    Feb 2013
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Rom parity error 998 fanuc

    Technician came in today and reloaded parameters got the same error looking into fixing hardware bad rom or board thanks for the reply

    Thank you for the reply

  4. #4
    Join Date
    Feb 2013
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Rom parity error 998 fanuc

    Ok so the technician replaced bad rom oe1 and reloaded parameters the machine is back online

Similar Threads

  1. Daewoo Fanuc rom parity error 998 122C6
    By rweaver in forum Machine Repair & Troubleshooting
    Replies: 1
    Last Post: 12-08-12, 10:55 AM
  2. Fanuc om Alarm 911 parity high error
    By cvmw in forum Machine Repair & Troubleshooting
    Replies: 1
    Last Post: 06-07-11, 10:47 AM
  3. FANUC 16-GC with 912 RAM PARITY ERROR
    By rfonsecajr in forum Introduce Yourself
    Replies: 0
    Last Post: 01-12-10, 09:48 AM
  4. Fanuc 0M-C --- 914 Ram Parity Error
    By rajappa in forum Fanuc Controls
    Replies: 1
    Last Post: 06-11-08, 06:21 PM
  5. Fanuc 18M 914 SRAM Parity error
    By toolholder in forum Fanuc Controls
    Replies: 2
    Last Post: 12-23-07, 07:38 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •