OKK machines

[f j moss]

Would someone kindly advise if they are a user of a OKK PCH400/500 machine with Fanuc 15mA and 100 tool capacity please. We could user some screnn info help on the tool setting area.

[Heinz Putz]

I do not have one, but I trained many shops that bought them.
Tell us the actual question and I am pretty sure you will get an answer.
Program examples are on the Mill section on my website
Heinz at www.doccnc.com

[f j moss]

Thank you Hienz for replying to me.

The problem area we have is the correct loading of the tool table on the Data PMC Table D112~D212 where I believe D112 is the spindle location and D113~D212 the remaing pot positions in numerical order. (Oh the Fanuc had suffered a memory loss). We have a OKK alm EX001 tool not found when we command the T no, although we have set the table.

I remember on the older OKK's we always had to set this table first, and then the software adjusted and altered the table as required during operation.

We need the explanation for D72~D80 and D82~D100, we beleive this is the spindle, waiting pot and magazine postion information.

We know there is a code M32 and M33, but not sure how to use these as we do not have the OKK manuals.

Thanking You Kindly.
F J Moss