Discovered on another forum that the G76 is NOT the same as for a Fanuc control. I had it programmed like a Fanuc control. There weren't any alarms. Checked the programming manual, and my bad.

What is happening is it won't make any spring passes. Not sure the compound infeed is changing either. Would prefer to fix the machine if possible than to re-program for a different cycle. I've called Yang, and was given a cell phone number to call. Left a message last week but haven't received a call back yet.

I did remove the Q in the first block and added decimal points to the P and Q in the second block. If I remember correctly it was making 10 passes before and is making 11 now. However, increasing the spring pass value DOES NOT increase the number of passes.

Thanks for any help.