Results 1 to 4 of 4

Thread: problem in sinumerik 840d

  1. #1
    Join Date
    Nov 2011
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Question problem in sinumerik 840d

    when chenge tool i found this massege:

    axis MAG countor moitiring.

    what can i do??

  2. #2
    Join Date
    Oct 2008
    Posts
    664
    Thanks
    3
    Thanked 94 Times in 76 Posts

    Default Re: problem in sinumerik 840d

    What kind / brand / model / type / color of machine are you talking about?

    Does the alarm show up with a prefix before the description ( a number) ?

    If you have a servo-driven tool magazine, CONTOUR MONITORING on that servo usually means that the load has been increased because of a mechanical failure, you have to check that or the motor itself.
    Last edited by Sinumeriko; 11-18-11 at 09:54 AM. Reason: Added color, ha.

  3. #3
    Join Date
    Nov 2011
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: problem in sinumerik 840d

    machine kinde : dekel maho 220L
    COTROL TYPE: SINUMERK 840D
    massege:25050 Axis MAG contour monitoring


    Description of the problem:
    Kit when you change the axis of movement inside and leave the kit in place of the number and after leaving the kit supposed to be pregnant and the number is going to attract the required kit stop the machine and this message appears.

  4. #4
    Join Date
    Oct 2008
    Posts
    664
    Thanks
    3
    Thanked 94 Times in 76 Posts

    Default Re: problem in sinumerik 840d

    A servo-driven mechanism has increased the load on its corresponding servomotor, beyond the tolerance point written at machine data #36400 (Contour tolerance).

    See what servomotors work in a tool change cycle, if none, it could be due to some sorf of a braking system in the spindle mechanism, perhaps at the moment of orientation.

Similar Threads

  1. how to disable the axis in Sinumerik 840D
    By vavco in forum Machine Repair & Troubleshooting
    Replies: 0
    Last Post: 04-15-13, 04:26 AM
  2. Sinumerik 840D
    By anjum in forum Machine Repair & Troubleshooting
    Replies: 5
    Last Post: 12-17-12, 06:35 PM
  3. Stop and reposition in Sinumerik 840D
    By Mariusssj in forum Programming / Applications
    Replies: 1
    Last Post: 06-01-12, 07:58 AM
  4. Z axis problem in VMC machine, 840D siemens control
    By Tanweer in forum Machine Repair & Troubleshooting
    Replies: 4
    Last Post: 04-26-11, 02:02 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •