Results 1 to 2 of 2

Thread: Fanuc SP230 Power up issue

  1. #1
    mwescott Guest

    Default Fanuc SP230 Power up issue

    We have a Fanuc SP230 controller operating our Hatachi EDM. We had an issue when powering up the controller sometimes it would take many tries to get the controller to stay on. Now it wont start at all. All power supplies seem to be fine. You can see the relay that powers up when you press the start button but then it releases seconds afterwards. If you have some advise it would be appreciated. I would also be willing to pay for a repair manual or schematic.

  2. #2
    BigDaddyFUFU Guest

    Default

    Call Terry Helms . 317-401-0221. He is in Indy and he can fix it for you.

Similar Threads

  1. FANUC Pro 3 G68 Issue
    By Christian1029 in forum General CNC & Manufacturing Discussion
    Replies: 0
    Last Post: 10-11-12, 11:05 AM
  2. Troubleshooting Possible Power Supply Issue?
    By WorkingDogs in forum Machine Repair & Troubleshooting
    Replies: 6
    Last Post: 03-21-11, 04:39 PM
  3. Fanuc Ot control ZRN issue
    By christate20000 in forum Fanuc Controls
    Replies: 5
    Last Post: 09-07-10, 10:09 AM
  4. Fanuc Power mate D backup in Fanuc flash card
    By Guest in forum Fanuc Controls
    Replies: 5
    Last Post: 09-06-10, 09:02 AM
  5. power supply FANUC 11
    By wanchai101 in forum Fanuc Controls
    Replies: 1
    Last Post: 08-02-08, 06:37 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •