Results 1 to 2 of 2

Thread: 003 Parameter error

  1. #1
    Join Date
    Aug 2010
    Location
    Western Michigan
    Posts
    12
    Thanks
    0
    Thanked 1 Time in 1 Post

    Default 003 Parameter error

    We are getting a 003 parameter error when trying to do a canned face execution. We want to cut identical pieces off a 1" diameter shaft and are trying to use the Face canned cycle. Our lathe is a Clausing EL 1545 with a Fagor 800T control. I figure the z coordinates should be 0.0 for both the begin & end points. The x is the only one to move. We are setting the diameter at 1" & one pass. We don't get any movement.

  2. The Following User Says Thank You to tedh For This Useful Post:

    kcho (02-16-12)

  3. #2
    Join Date
    Jan 2010
    Location
    Caseros, Argentina
    Posts
    3
    Thanks
    3
    Thanked 0 Times in 0 Posts

    Default Re: 003 Parameter error

    Try to see the Programming manual

Similar Threads

  1. Parameter Error
    By sowfb in forum Machine Repair & Troubleshooting
    Replies: 4
    Last Post: 11-01-13, 04:05 PM
  2. error 7001 nv parameter not set problems
    By jm2625 in forum Introduce Yourself
    Replies: 0
    Last Post: 07-25-11, 07:08 PM
  3. Matsuura Mc500v seq error/magazine error
    By MC500V in forum Machine Repair & Troubleshooting
    Replies: 2
    Last Post: 02-03-09, 10:12 AM
  4. Replies: 0
    Last Post: 09-09-06, 04:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •