Doosan Puma 240m

[bkwalker]

We have a Doosan Puma 240M lathe running the Fanuc series 32i-Model A control with eZ Guide i installed. I am tring to figure out how (if possible)the swing some OD slots with the X and C axis. Thought we had it figured out using G112 and using C address instead of Y but didn't work like I was hoping. Any help is appreciated and if you have little sample program that shows how to switch to X Y polar coordinates that would be awesome. Thanks.

[Strat]

Using the X & C axes is how you would do that type of operation. Are you doing the calculations by hand? What alarms are you getting? If the function operates properly and it's just a sizing error then it's obviously a math error or set up error.
Good Luck!