Results 1 to 4 of 4

Thread: KIA 15/21 Yasnac LX-3 Alarm 280

  1. #1
    Join Date
    Apr 2011
    Posts
    9
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Question KIA 15/21 Yasnac LX-3 Alarm 280

    I have a KIA 15/21 Lathe and am getting Alarm 280: Machine unready. I can run the machine for around 50 minutes and than i get this alarm in the process of making a piece. Turn-off machine and reset and it works for another 50 minutes. Any Ideas

  2. #2
    Join Date
    Dec 2010
    Posts
    43
    Thanks
    1
    Thanked 3 Times in 3 Posts

    Default Re: KIA 15/21 Yasnac LX-3 Alarm 280

    hi, could you solve you trouble? what was the problem?

  3. #3
    Join Date
    Apr 2011
    Posts
    9
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: KIA 15/21 Yasnac LX-3 Alarm 280

    This problem was intermittent Sometimes it would happen and sometimes it would run fine. The past 2 months we had a lot of problems with a certain product and program. The Spindle drive unbit would show an alarm when the screen displayed a 280 alarm. I adjusted some of the settings within the spindle drive such as the braking time and other settings related to the braking resistir and timing. I also changed a setting that said what kind of resistors they are, I turned it to Disable. This worked well and have no problems for 30 days. I dont know if changing the setting to disable will cause other problems though.

  4. #4
    Join Date
    Dec 2010
    Posts
    43
    Thanks
    1
    Thanked 3 Times in 3 Posts

    Default Re: KIA 15/21 Yasnac LX-3 Alarm 280

    Have you check the circuit related to the "machine ready"?
    There is a relay that send you this signal. May be the relay is bad, you can try changing it.

    Regards

Similar Threads

  1. kitamura mycenter 3x w/ yasnac i80 alarm 2040
    By dphelps in forum Yasnac / Yaskawa Controls
    Replies: 0
    Last Post: 11-17-17, 10:01 AM
  2. need help yasnac control 172 memory erro alarm
    By karthick in forum Yasnac / Yaskawa Controls
    Replies: 0
    Last Post: 05-14-13, 03:16 AM
  3. Hitachi Seiki HT20SII / YASNAC/ SEICOS LX3 Alarm message. pls help!
    By Piccadilly in forum Machine Repair & Troubleshooting
    Replies: 2
    Last Post: 10-10-12, 10:30 AM
  4. KIA/Yasnac Alarm code 280: Machine Unready
    By makinpieces in forum Machine Repair & Troubleshooting
    Replies: 2
    Last Post: 05-05-11, 10:43 AM
  5. Alarm code 2131 ABS POS CHECK ERROR (X) yasnac i 80 M
    By saptyawan in forum Yasnac / Yaskawa Controls
    Replies: 0
    Last Post: 01-15-08, 12:16 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •