Results 1 to 3 of 3

Thread: FANUC 0T

  1. #1
    Join Date
    Mar 2007
    Location
    Jundiaí - São Paulo - Brazil
    Posts
    75
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default FANUC 0T

    Anyone knows the parameter to change the degree in an lathe that has Fanuc 0T control ??? I want to change the M19 !!!

    Thanks a lot

    Daniel

  2. #2
    Join Date
    Nov 2006
    Location
    Lewisville(New Castle Area), Indiana
    Posts
    233
    Thanks
    0
    Thanked 14 Times in 12 Posts

    Default

    I believe it is 589. 587 should be value of M code specifying (19), 588 should be value of M code cancelling, and 589 should be the position reading.
    Cody Stamper



    (Note: The opinions expressed in this post are my own and are not necessarily those of cnc-professional-forum.com and its management)

  3. #3
    Join Date
    Nov 2006
    Location
    Lewisville(New Castle Area), Indiana
    Posts
    233
    Thanks
    0
    Thanked 14 Times in 12 Posts

    Default

    Those parameters I listed will also depend on the model of 0T control you have. It may be a pot gain adjustment on the orient board in the control cabinet.
    Cody Stamper



    (Note: The opinions expressed in this post are my own and are not necessarily those of cnc-professional-forum.com and its management)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •