Results 1 to 3 of 3

Thread: emco sinumerik 810m help needed

  1. #1
    Join Date
    Dec 2010
    Location
    Tripoli/LIBYA
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Unhappy emco sinumerik 810m help needed

    hi gents,
    i need a copy of a back up parameters for EMCO VMC300 milling machine
    sinumerik 810M and set up procedure for connecting with pc via RS232 cable
    communication set up that I have ready on my pc as :
    1 - TYPE: normal-ASCII-ISO
    2 - COM PORT: 1
    3 - Parity:NONE
    4 - Stop Bits: 2 Stop Bits
    5 - Hand Shaking: XON/XOFF
    6 - SEND TYPE: LINE
    7 - XON/XOFF: DC1/DC3
    8 - BAUD RATE: 9600
    9 - DATA BITS:8 Bits
    10 - WAITING FOR SIGNAL: OFF
    i need to know how to put the same previous values in the CNC
    thanks in advane for any help
    Last edited by nabil; 12-23-10 at 05:39 PM.

  2. #2
    Join Date
    Oct 2009
    Posts
    38
    Thanks
    2
    Thanked 4 Times in 4 Posts

    Default Re: emco sinumerik 810m help needed

    hi
    5010 00000000 5011 11000111
    5012 00000000 5013 11000111
    enaugh for you.if not to be.i can send more inform.
    best regards

  3. #3
    Join Date
    Dec 2010
    Location
    Tripoli/LIBYA
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: emco sinumerik 810m help needed

    thank u for ur reply ibrahim
    the parameter u sent is it matching with my set up for the data transfer that I have on my PC as I mentioned in my previous thread???
    and if possible please send me all the parameter to bring the machine to work if u got them.
    thanks again
    regards
    Attached Thumbnails Attached Thumbnails 23122010338.jpg   23122010347.jpg  

Similar Threads

  1. Sinumerik 810M GA3
    By cchumi in forum Siemens Controls
    Replies: 11
    Last Post: 12-28-17, 01:52 AM
  2. software for CNC SINUMERIK 810M GA1/ 6FC34711AAZ
    By rhouma00 in forum Siemens Controls
    Replies: 1
    Last Post: 05-25-15, 05:56 AM
  3. Backup SINUMERIK 810M GA3
    By Peter Daniel in forum Machine Repair & Troubleshooting
    Replies: 8
    Last Post: 03-30-12, 10:45 PM
  4. Cycle L96 for EMCO VMC300 (Sinumerik 810 GA3)
    By gkocic in forum General CNC & Manufacturing Discussion
    Replies: 0
    Last Post: 06-09-11, 01:45 PM
  5. S5D example for Sinumerik 810m needed
    By stevavoj in forum Machine Repair & Troubleshooting
    Replies: 4
    Last Post: 10-22-10, 09:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •