Results 1 to 5 of 5

Thread: fanuc cnc control OT

  1. #1
    Join Date
    Oct 2010
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default fanuc cnc control OT

    installed a new board on front control panel.
    now when we start up, we get a 1010 and a 1011 alarm
    dry run lite stays on as well as the optional stop lite
    anyone experience this trouble? can not run machine
    in this condition.
    1010 alarm says tool touch option installed
    1011 alarm says cover or arm must be on.

  2. #2
    Join Date
    Aug 2008
    Location
    huber heights, ohio
    Posts
    179
    Thanks
    2
    Thanked 12 Times in 12 Posts

    Default Re: fanuc cnc control OT

    have you checked the card to see if all the numbers match? what model/brand of machine is this on?

  3. #3
    Join Date
    Oct 2010
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: fanuc cnc control OT

    this is on a hardinge CHNC w/fanuc OT control

  4. #4
    Join Date
    Sep 2005
    Location
    Wisconsin
    Posts
    1,005
    Thanks
    5
    Thanked 75 Times in 65 Posts

    Default Re: fanuc cnc control OT

    Incase someone happened to bump it or play with it while the machine was down. Is there a cover that goes on the place where the removable tool presetter goes and is it on properly? Depending on the model there can be a magnet that falls out of the cover. What happens if you attach the presetter does it go away? Unless this is an automatic presetter that goes down and up by itself check that it is retracted all the way.

  5. #5
    Join Date
    Oct 2008
    Posts
    664
    Thanks
    3
    Thanked 95 Times in 77 Posts

    Default Re: fanuc cnc control OT

    Here's another possibility, it might be that your new board has a newer firmware, look and see in the older one, search for a removable EPROM chip, there is a label with a version number placed on it, if it is different than the newer but still the EPROM is the same kind of chip, you could carefully swap them and test.

Similar Threads

  1. Fanuc 16 control
    By e44sp in forum Programming / Applications
    Replies: 1
    Last Post: 12-13-13, 06:52 AM
  2. Need help with Fanuc control OM
    By gus2012 in forum Fanuc Controls
    Replies: 6
    Last Post: 07-07-12, 09:02 AM
  3. fanuc motors drives other than fanuc control
    By bdrk in forum Machine Repair & Troubleshooting
    Replies: 2
    Last Post: 03-01-11, 10:46 PM
  4. fanuc OM can mot control Z
    By asmvn in forum Machine Repair & Troubleshooting
    Replies: 3
    Last Post: 08-29-10, 10:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •