Results 1 to 4 of 4

Thread: tools

  1. #1
    Join Date
    Dec 2009
    Posts
    53
    Thanks
    1
    Thanked 0 Times in 0 Posts

    Default tools

    I can't seem to figure out how to set tools and identify tools on a Mazak MT-V-414 mill. how does the program know which tool does what since there is no place to put a tool number. Thanks Tony
    Last edited by tonyk1; 12-28-09 at 11:23 PM.

  2. #2
    Join Date
    Dec 2009
    Location
    ca
    Posts
    16
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: tools

    Hi
    You must write T01 in your program and make the G54 with this tool but if you want use more that one tool in your program you mast change the tools by hand and then movement the z value of G54 for amount of offset if you don't have tool offset page.
    Be successful

  3. #3
    Join Date
    Dec 2009
    Posts
    53
    Thanks
    1
    Thanked 0 Times in 0 Posts

    Default Re: tools

    I can't seem to figure out how to set tools and identify tools on a Mazak MT-V-414 mill using Mazatrol. how does the program know which tool does what since there is no place to put a tool number. Thanks Tony

  4. #4
    Join Date
    Dec 2009
    Location
    ca
    Posts
    16
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: tools

    Ok
    After measurement of your length tools by tool preset or your machine you can write this difference of length(offset of you tools)in a paper ,then load your program and run it ,and when the machine want to change the tool 1, you can change the value of G54 in Z axes for amount of difference length of tool number 1 to tool number 2 and then continue the program.
    my English language is not good,i hope you can use of my experience.

Similar Threads

  1. NEW CNC installtion tools
    By sensor pro in forum Machine Repair & Troubleshooting
    Replies: 0
    Last Post: 07-06-12, 03:37 PM
  2. Anybody need help with Haas and other CNC machine tools!
    By HARVEY in forum Machine Repair & Troubleshooting
    Replies: 1
    Last Post: 11-11-11, 11:59 PM
  3. Granite tools on cnc
    By DAVE in forum General CNC & Manufacturing Discussion
    Replies: 3
    Last Post: 12-20-10, 02:08 PM
  4. Cnc stone tools
    By DAVE in forum General CNC & Manufacturing Discussion
    Replies: 1
    Last Post: 06-10-10, 08:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •