Results 1 to 3 of 3

Thread: Fanuc OM control/1997 Clausing Kondia

  1. #1
    Join Date
    Nov 2018
    Location
    Fairview, Pa. 16415
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Fanuc OM control/1997 Clausing Kondia

    I am getting an error message: 320 APC alarm-Y axis need ZRN
    I just had the servo motor for X axis reconditioned by Fanuc and after installing, the Y and X axis won't home.
    Before I removed the servo motor, the Y axis worked just fine.
    We also switched the cables of the X and Y at the Servo Amplifier Module and the problem still existed in the motor.
    We wanted to make sure that the Servo Amplifier was the problem. We made absolutely sure the cables were switched back to the correct locations.
    I would appreciate if someone can tell me what the error message means and what the problem might be.

  2. #2
    Join Date
    Jun 2018
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Fanuc OM control/1997 Clausing Kondia

    You need to perform the Y axis resetting procedure as you have disconnected the encoder from the amplifier
    What control is on it

  3. #3
    Join Date
    Nov 2018
    Location
    Fairview, Pa. 16415
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Fanuc OM control/1997 Clausing Kondia

    I've contacted Fanuc Tech services and resolved that problem. I discovered the real problem I had was the ball nut and screw for the X axis. I can run the machine now with minimal movement in the X axis. I'm doing my machining in Y. I will try to sell the machine as is or piece it out. There seems to be a demand for the Servo Motors and the X axis Servo Motor was just reconditioned by Fanuc. It would be a good machine if someone wanted to put a little money into it. The vultures on other websites want to give scrap prices for good machines.
    I'm 68 years young, don't really need the money, and don't see myself working much longer.
    Thank you for your response!!!

Similar Threads

  1. 1997 Clausing Kondia with Fanuc OM control
    By MMT in forum Fanuc Controls
    Replies: 0
    Last Post: 11-01-18, 12:39 PM
  2. Clausing Gearhead Oil
    By tedh in forum General CNC & Manufacturing Discussion
    Replies: 0
    Last Post: 04-05-11, 06:12 AM
  3. Fanus 21i on a clausing/storm lathe
    By radically machine design in forum Machine Repair & Troubleshooting
    Replies: 13
    Last Post: 04-20-09, 05:08 PM
  4. Operational Noise - Clausing Colchester 15 Triumph Lathe
    By Guest in forum General CNC & Manufacturing Discussion
    Replies: 4
    Last Post: 07-11-06, 09:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •