Running a MultiCam A series router (old from around 2004 but has been great for our usage) however now it's not homing correctly. It finds Z and Y perfectly fine like normal but when finding X it is moving to the right of the table (if i recall correctly it normally goes to the left), extremely slow and once it reaches the right end it continues to try to go further but physically can't so I have to stop it. I don't ever receive an error while it's doing this until I manually stop it and try to do anything else I get promts such as "System Interrupt: X Home" or "Limit Still Active X Home". I am unable to move

Any help would be greatly appreciated! I tried contacting tech support but they weren't much help and recommended sending a tech onsite but that is more than a week out and quite expensive. Thank you in advance!