Results 1 to 4 of 4

Thread: Surface Roughness Problem

  1. #1
    Join Date
    Sep 2018
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Surface Roughness Problem

    I have a block of Mild Steel 50X50X22 and I want to machine this block into 50X50X20 with the surface finish of 50micrometer. Is this is possible on VMC or I have to go on surface grinder for such finish.

  2. #2
    Join Date
    Aug 2018
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Surface Roughness Problem

    50x50x22? Inches, mm, cm?

  3. #3
    Join Date
    Sep 2018
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Surface Roughness Problem

    All dimensions are in mm

  4. #4
    Join Date
    Aug 2018
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: Surface Roughness Problem

    I'm assuming you mean 50 Ra for finish. 2 mm is not that much to remove. I'd use the surface grinder, easier to square up and easier to control.

Similar Threads

  1. Helical spiral groove onto curved surface?
    By Doug Overkill in forum Programming / Applications
    Replies: 13
    Last Post: 12-23-14, 05:00 AM
  2. driiling without spot drilling on a flat surface?
    By rahul rawat in forum Programming / Applications
    Replies: 0
    Last Post: 12-18-14, 03:03 AM
  3. Correct Way to use Constant Surface Speed
    By medger1 in forum General CNC & Manufacturing Discussion
    Replies: 4
    Last Post: 01-25-13, 07:06 AM
  4. Constant Surface Feed Parameter
    By JohnKyle in forum Machine Repair & Troubleshooting
    Replies: 3
    Last Post: 02-28-12, 10:12 AM
  5. Protrusion on Al surface after CNC Milling
    By Kenny in forum Programming / Applications
    Replies: 0
    Last Post: 03-05-10, 02:31 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •