Hi. Just joined this forum. I am looking for help/advise in getting 3 old Fanuc Tape Drill Mate Model T cnc's up and running.
I have 220v 3p power via a digital phase converter to each machine, a fresh set of batteries installed, and the paper printouts of the parameters.

How do I go about installing in the parameters? I am expecting to hand type them in, as I do not have a pc hooked up to them yet.

FYI... I have a Haas VF-1 running on the the same phase converter and cutting chips with zero issues, so I feel I should be able to get these Robo's running successfully
with some help.

Thanks!

John