Results 1 to 2 of 2

Thread: HEIDENHAIN iTNC530 ALARM

  1. #1
    Join Date
    Feb 2018
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default HEIDENHAIN iTNC530 ALARM

    hello . my machine HEIDENHAIN iTNC530
    when i just press on power bottom all axis give me to much vibration and the display got this message
    8650 IZT value of power module is too high
    the error display with all axis
    first with x and when i press any key its indicates with y and then with z
    its appear with all axis succession
    1 i replace the all drivers from other machine x and y and z and power supply
    2 i check all bearing . it is OK .also i check all rollers x and y and z . it is OK
    3 i disconnect the x axis and try to run
    4 i disconnect the y axis and try to run
    5 i disconnect the z axis and try to run
    same problem . and all drivers is running good on other machine
    can any one help me please?

  2. #2
    Join Date
    Feb 2018
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default Re: HEIDENHAIN iTNC530 ALARM

    please help

Similar Threads

  1. HEIDENHAIN TNC530
    By CHANDRU in forum Automation & Interfacing / Installation / Ladder logic
    Replies: 3
    Last Post: 11-11-11, 10:27 AM
  2. DMG / Heidenhain problems
    By Garyt in forum Machine Repair & Troubleshooting
    Replies: 3
    Last Post: 11-11-11, 10:25 AM
  3. Deckel Maho v1035 /Heidenhain iTNC530/
    By ahuta in forum Machine Repair & Troubleshooting
    Replies: 0
    Last Post: 09-26-11, 05:37 AM
  4. Heidenhain-iso converter
    By dowen in forum Machine Repair & Troubleshooting
    Replies: 1
    Last Post: 07-06-10, 11:26 PM
  5. Heidenhain tnc135b
    By CHANDRU in forum Machine Repair & Troubleshooting
    Replies: 2
    Last Post: 06-22-09, 08:32 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •