Hi all,

I am new to the forum and hoping for some help.

I have a Meba 320DGA CNC Bandsaw which requires a particular Hohner Encoder (Serie KHE86 SUCO NET KI encoder). I am trying to locate one of these encoders. I have a one page information sheet about this encoder but it is not enough detail. If somebody had the full manual / more information on the KHE86 encoder that would also be very helpful.

Alternatively, I have a similar encoder (Hohner BC58 0013 EK42 USB encoder) which it should be possible for a computer programmer to make the machine compatible with. Does anybody have any experience of such computer programming who might be able to help? SUCONet is the interface that it uses I think. Perhaps if somebody had any experience of developing a SUCONet gateway to allow you to use another network interface instead of it.

I have been in touch with Meba but they said there are no original encoders for these machines available to buy. I understand Hohner have discontinued all encoders of this type.

Any help or advice would be greatly appreciated
Thanks in advance