Search:

Type: Posts; User: RON F; Keyword(s):

Search: Search took 0.01 seconds.

  1. Replies
    0
    Views
    1,242

    G54 g55 g56 work coordinate

    Hey anyone know why my machine will not repeat a work coordinate g54 ,runs right to the center of part 1st time , but after going home, on the next run it tries to go backwards and over travels,...
  2. Replies
    1
    Views
    1,137

    Re: Ooya vmc 1100 lube lines broken

    OK i found that giving the tube a turn back and forth that they will losen and come out , and some broke off ,on those i used a small drill to drill out the piece that was left in the hole ,the ones...
  3. Replies
    1
    Views
    1,137

    Ooya vmc 1100 lube lines broken

    HELLO GUYS , HAS ANYONE REMOVED THE LUBE LINES FROM THE WAYS ,I TRIED TO PULL ONE THAT WAS BROKEN OUT ,IT JUST SNAPPED OFF IN THE WAY , MUST BE A WAY OF REMOVE
    L ,LOOK TO BE JUST PUSHED IN THE HOLE...
  4. Replies
    2
    Views
    2,040

    Re: Ooya vmc 1100 fanuc control

    I found that the spindle control that was replaced with a repaired one that wasn't programed for the machine . When we got the original control repaired .and replaced it , it worked fine then.
  5. Replies
    0
    Views
    1,136

    ooya re-1m 4th axis

    hello
    need help with ooya fanuc control 6m ,i want to disable the 4th axis, is there a parameter to change or is it more diffacult than that ,been looking at the maintenance manual parameter list...
  6. Thread: Error 904

    by RON F
    Replies
    1
    Views
    1,693

    Error 904

    Fanuc 6m control we have a 904 error on screen ,manual says fault in bubble device(parity error)
  7. Replies
    2
    Views
    2,040

    Ooya vmc 1100 fanuc control

    Need help w/h spindle oriention spindle turns but does not stop
    light on sensor flashes when magnet passes and no spindle
    speed on screen when running spindle.
Results 1 to 7 of 7