Search:

Type: Posts; User: R.D.O.; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,848

    Re: Are linear slide bearing balls replacable?

    I FOUND VID OF BALLSCREW REBUILD ON U TUBE. THERE SHOULD BE SOMETHING ON BEARINGS TOO. OR http://thomsonlinear.com/website/com/eng/index.php TRY THOMSON SUPPORT.
  2. Replies
    2
    Views
    2,076

    Re: Glentek servo amplifier burnt !

    Any body that has had dms 5-axis router trouble ? ?
  3. Replies
    2
    Views
    2,076

    Glentek servo amplifier burnt !

    Crushed Cables have led to alotta problems. The newest is a GLENTEK/SMA9615.
    Need one ASAP. Anyone got any leads asto where there might be one in stock?
    Any and all help will be greatly...
  4. Thread: Thermwood gen 2

    by R.D.O.
    Replies
    0
    Views
    792

    Thermwood gen 2

    Thermwood gen 2 control system. I have to pull the profibus card to erace c marker values. Any input would help alotta people.
  5. Re: mazak 3l, x&z axis run in opposite direction in G00 command

    I'm not up on that control sysyem, but if its not wireing then look for axis transpose codes. I use thermwood, g26. Or fagor g28. Bet it's wireing though.
  6. Re: mazak 3l, x&z axis run in opposite direction in G00 command

    If programming is long withstanding, then it must be wireing. Limit switches are usually wired with sheilded cable. Could be that stray voltage from + to - is happening from introduction to fluid....
  7. Replies
    2
    Views
    1,932

    Re: 5-axis dms router down!

    I will have a gearbox friday. Thanx!
  8. Replies
    2
    Views
    1,932

    5-axis dms router down!

    I need a gear box. Its a gam, elp series. My suppliers cant find one. Anyone that can help would be greatly appreciated.
Results 1 to 8 of 8