Tsudakoma TPC-Rz 4th axis controller - CNC Professional Forums

#1 (permalink)

02-11-12, 09:23 PM

bhayden

CNC Tech

Join Date: Jan 2010

Posts: 1

Thanks: 0

Thanked 0 Times in 0 Posts

Tsudakoma TPC-Rz 4th axis controller

Does anyone have a manual or programming information for a Tsudakoma TPC-Rz 4th axis controller. I recently purchased a used system but cannot find any information on the programming of this controller. i can operate the control in "jog" mode and "single step" mode but can't quite figure out the programming protocol. Any help would be appreciated.

Bookmarks

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules

IMPORTANT DISCLAIMER

You may not post new threads

You may not post replies

You may not post attachments

You may not edit your posts

BB code is On

Smilies are On

[IMG] code is On

HTML code is Off

Trackbacks are On

Pingbacks are On

Refbacks are Off

Forum Rules

Although The CNC Professional Forum has attempted to provide accurate information on the forum, The CNC Professional Forum assumes no responsibility for the accuracy of the information. All information is provided "as is" with all faults without warranty of any kind, either express or implied. Neither The CNC Professional Forum nor any of its directors, members, managers, employees, agents, vendors, or suppliers will be liable for any direct, indirect, general, bodily injury, compensatory, special, punitive, consequential, or incidental damages including, without limitation, lost profits or revenues, costs of replacement goods, loss or damage to data arising out of the use or inability to use this forum or any services associated with this forum, or damages from the use of or reliance on the information present on this forum, even if you have been advised of the possibility of such damages.

All times are GMT -5. The time now is 09:08 PM.