MulitCam MG 205 boot failure

[bbeem]

When powering on our MultiCam MG 205 router it fails to go through the bootup sequence. The screen has only a blinking cursor. The motherboard shows a solid red light labeled dust collector and a blinkling led labeled "bad". The Router froze and was not responding; after powering it down it no longer boots.

[JaseB]

I would call Multicam. If you can get a hold of one of their technicians, they can work wonders over the phone as far as helping you test voltage and confirm if a driver/board is bad. I have dealt with the same technician on several occasions, and they are helpful, but not exactly timely when it comes to calling you back.
Fill out this request form: http://www.multicam.com/eng/Support/tsreq.php
or
Call 972.929.4070 and press 5 for tech support.
Have your serial number handy...

I have a machine that was a retrofit done by multicam, and its quite the Frankenstein, but they were able to help me dial down voltage on a card, confirm that a driver was bad, and then send me the correct replacement card. This was a 10+ year old machine and they didn't bill me a dime for the technical support, just the motor itself.

[jacu]

Dear bbem,
Do you repair the problem?
For me the problem is on the power supply of the control. This device have 5 VCC, but if this value is 4,85 the control don't boot.
Regards,
jacu